Installing the cover on rear bumper cover
- Position the cover (1) and engage at the detents (2) along the dotted line.
NOTE:
The description is provided only at one component. The procedure is the same for all other components.
- Install the ultrasonic sensor (2) and engage at the detents (1).
Follow-up work
- Refer to INSTALLING THE REAR BUMPER COVER .
- Refer to INSTALLING RIGHT REAR REFLECTOR .
- Refer to INSTALLING LEFT REAR REFLECTOR .
- Refer to INSTALLING THE TRIM IN THE WATER CHANNEL ON THE LEFT AND RIGHT .
- Refer to INSTALLING THE TAIL LIGHT ON THE LEFT AND RIGHT SIDE PANEL .
- Refer to INSTALLING BOTH BOTTOM D-PILLAR TRIM PANELS .
- Refer to INSTALLING THE WARNING TRIANGLE .
- Refer to INSTALLING THE LEFT AND RIGHT FLAP IN THE LUGGAGE COMPARTMENT TRIM PANEL .