Installing the rear bumper cover
- Guide in bumper cover (2) and connect and lock all the plug connections while doing this.
- Snap in the front bumper cover (2) in the locks in the area of the side panel.
NOTE:
Perform the steps on the right and left side.
- Tighten down screws (1)
.
There is no screw under the reflector during the life cycle impulse of vehicles.
TIGHTENING TORQUE SPECIFICATIONS
| Bumper panel, rear | ||
| Hexagon screw | Tightening torque | 2.5 Nm |
- Tighten down screws (1) .
TIGHTENING TORQUE SPECIFICATIONS
| Bumper panel, rear | ||
| Hexagon screw | Tightening torque | 2.5 Nm |
NOTE:
Perform the steps on the right and left side.
- Tighten down screws (1) .
TIGHTENING TORQUE SPECIFICATIONS
| Bumper panel, rear | ||
| Hexagon screw | Tightening torque | 2.5 Nm |
NOTE:
Perform the steps on the right and left side.
- Check the clip (2)
, it must not damaged or missing.
Clip, (2) always install with the sealing ring.
- Check detents (3) , they must not be damaged or missing.
- Clip in the wheel arch trim (1) with the clip (2) .
- Engage the wheel arch trim (1)
into the detents (3)
in the area of the bumper cover.
- Refer to Mount blind rivet (1) using the special tool 0 496 521 (00 2 230) .
Follow-up work
- Refer to INSTALLING RIGHT REAR REFLECTOR .
- Refer to INSTALLING LEFT REAR REFLECTOR .
- Refer to INSTALLING THE TRIM IN THE WATER CHANNEL ON THE LEFT AND RIGHT .
- Refer to INSTALLING THE TAIL LIGHT ON THE LEFT AND RIGHT SIDE PANEL .
- Refer to INSTALLING BOTH BOTTOM D-PILLAR TRIM PANELS .
- Refer to INSTALLING THE WARNING TRIANGLE .
- Refer to INSTALLING THE LEFT AND RIGHT FLAP IN THE LUGGAGE COMPARTMENT TRIM PANEL .