Install the front top cross connection
- Attach the front top cross connection (2) .
- Tighten the screws (1) .
TIGHTENING TORQUE SPECIFICATIONS
| Top front cross connection to hood lock support | ||
| screw | Tightening torque | 11.8 Nm |
Follow-up work
- Refer to INSTALLING AIR DUCT .
- Refer to INSTALLING REINFORCEMENT STRUT .
- Refer to INSTALLING THE TOP AIR FLAP CONTROL/AIR DUCT .
- Refer to INSTALLING THE FRONT HOOD SEAL .
- Refer to INSTALLING BUMPER COVER, FRONT .
- Refer to PARTIALLY INSTALLING THE FRONT SECTIONS OF BOTH WHEEL ARCH COVERS AT THE FRONT .
- Refer to PARTIALLY INSTALLING THE LEFT AND RIGHT FRONT WHEEL ARCH TRIM .
- Refer to INSTALLING FRONT ORNAMENTAL GRILLE .
- Refer to INSTALLING FRONT CROSS CONNECTION .
- Refer to INSTALLING THE COVER IN THE ENGINE COMPARTMENT AT TOP LEFT AND RIGHT .