Install chain tensioner
NOTE:
TECHNICAL INFORMATION
Collect and dispose of emerging fluids. Observe country-specific waste disposal regulations.
Collect and dispose of emerging fluids. Observe country-specific waste disposal regulations.
- Drain the oil chamber in the chain tensioner when reusing the chain tensioner.
- Place the chain tensioner on a level support, slowly compress in direction of arrow and relieve it.
- Catch and dispose of emerging motor oil.
- Repeat process 2 times.
- Replace the sealing sleeve (1).
Parts: Sealing sleeve
- Guide in and install the sealing sleeve (1) on the chain tensioner (2).
- Guide in and install the chain tensioner (1).
- Tighten chain tensioner (2) with commercially available tools (1).
TIGHTENING TORQUES SPECIFICATION
| Chain tensioner to cylinder head | ||
| Chain tensioner | Joining torque | 20 Nm |
| Angle of rotation | 40° | |
Follow-up work
- Refer to INSTALLING THE HEAT SHIELD ON THE CYLINDER HEAD .
- Refer to INSTALLING THE HOLDER OF THE POSITIVE BATTERY CABLE .
- Refer to INSTALLING THE CYLINDER HEAD COVER ACOUSTIC COVER .
- Refer to INSTALLING DIFFERENTIAL PRESSURE SENSOR .
- Refer to INSTALLING ACOUSTIC COVER AT REAR .
- Refer to INSTALLING THE COWL UPPER PART .
- Refer to INSTALLING TENSION STRUT ON LEFT AND RIGHT SHOCK TOWER .
- Refer to INSTALLING WINDSHIELD PANEL COVER .
- Refer to INSTALLING LEFT AND RIGHT WIPER ARM .
- Refer to INSTALLING THE REAR RIGHT ENGINE COMPARTMENT COVER .
- Refer to INSTALLING THE COVER OF THE ENGINE COMPARTMENT ON THE REAR LEFT .
- Refer to INSTALLING THE FRONT HOOD SEAL AT THE REAR .
- Refer to INSTALLING RESONATOR .
- Refer to INSTALLING ACOUSTIC COVER .
- Refer to TAKING HOOD OUT OF THE SERVICE POSITION .