Install windscreen

• Prepare the glue cartridge with the standard nozzle C.
• Apply bead joint in area (1)  .
• Apply adhesive bead within the mark on the windscreen.

  Cut	A-A	B-B	C-C
  a = Position of the adhesive bead	2 ±2 mm	3 ±2 mm	2 ±2 mm
  b= Width of adhesive bead	8 ± 1 mm	8 ± 1 mm	8 ± 1 mm
  h = Height of adhesive bead	12 ± 1 mm	12 ± 1 mm	12 ± 1 mm

  Courtesy of BMW OF NORTH AMERICA, INC.

• Adhere to the geometry of the adhesive bead to make sure that one glue cartridge is sufficient for the complete windscreen.
• Carefully perform the following operations on the windscreen (1)  with suction lifter:
  • running it in parallel to the A-pillar
  • feed it in the area (A) on left and right below the side panel
  • Position at top
  • Align sides evenly
  • Press upwards until sealing rests evenly on roof
  • press evenly all around
  • fix with adhesive tape on the roof

    Courtesy of BMW OF NORTH AMERICA, INC.

• Measure short length (A)  of the windscreen (1)  to the roof outer skin (2) with special tool  0 495 259 (51 0 010)  .
• Adjust short length (A)  .
  TECHNICAL DATA SPECIFICATION
  
  

  Gap dimension of windscreen to the body
  	Short length A	2.5 mm... 4.5 mm

  Courtesy of BMW OF NORTH AMERICA, INC.

• Position the windscreen (1)  in such a way that the rubber frame (3)  lies even and parallel to the roof outer skin (2)  .

Follow-up work 

• Refer to INSTALLING THE LEFT AND RIGHT A-PILLAR TRIM PANELS .
• Refer to CONNECTING CONNECTOR TO THE RAIN-LIGHT-SOLAR-CONDENSATION SENSOR .
• Refer to INSTALLING THE KAFAS CAMERA .
• Refer to INSTALLING THE INTERIOR MIRROR .
• Refer to INSTALLING THE COVER ON THE INSIDE MIRROR .
• Refer to INSTALLING THE REAR COWL PANEL .
• Refer to INSTALLING LEFT AND RIGHT WIPER ARM .
• Refer to INSTALLING FRONT WINDSHIELD PANEL COVER .
• Refer to INSTALLING THE GUTTER STRIP ON THE WINDSCREEN ON THE LEFT AND RIGHT .
• Refer to INSTALLING THE REAR HOOD SEAL .
• Refer to CALIBRATE KAFAS CAMERA .