Installing the left and right A-pillar trim panels
NOTE:
Description is for left component only. Procedure on the right side is identical.
Installing the A-pillar trim panel
WARNING:
Airbag unit
.
Danger! Immobilization period-threatening injuries!
Danger! Immobilization period-threatening injuries!
- Before performing any work on the airbag, always disconnect the battery ground lead from the battery.
- Airbag unit may only be set down with the cushion (airbag itself) facing upwards.
- For additional information see: SAFETY REGULATIONS FOR HANDLING COMPONENTS WITH GAS GENERATORS .
WARNING:
Pyrotechnic components
.
Danger! Immobilization period-threatening injuries!
Danger! Immobilization period-threatening injuries!
- All work on pyrotechnic parts may be carried out by technically experienced and appropriately trained personnel only.
- Replace any damaged part or ones that have been dropped.
- For additional information see: SAFETY REGULATIONS FOR HANDLING COMPONENTS WITH GAS GENERATORS .
NOTE:
TECHNICAL INFORMATION
Detents, guides and mounting elements must not be damaged or missing.
Detents, guides and mounting elements must not be damaged or missing.
- Insert the A-pillar trim panels (2) and clip into the clips (3) .
- Replace screw.
Parts: Screw
- Tighten down screw.TIGHTENING TORQUE SPECIFICATIONS
A-pillar trim panel to body M5x42 screw
Replace screwTightening torque 2.2 Nm - Clip in the cover (1) .