Installing the front bumper cover support
NOTE:
Perform the steps on the right and left side.
- Feed in and position the support for the front bumper cover (3) .
- Tighten down screws (2) .
TIGHTENING TORQUES SPECIFICATION
| Deformation element to engine mount | ||
|---|---|---|
| Hexagon screw M12 Replace screw. |
Tightening torque | 100 Nm |
| Angle of rotation | 180° | |
- Tighten down screws (1) .
TIGHTENING TORQUES SPECIFICATION
| Support to top deformation element | ||
|---|---|---|
| Hexagon screw M8x25 |
Tightening torque | 19 Nm |
- Connect all connectors and lock.
NOTE:
Perform the steps on the right and left side.
- Tighten down screw (1) .
TIGHTENING TORQUES SPECIFICATION
| Support to top deformation element | ||
|---|---|---|
| Hexagon screw M8x25 |
Tightening torque | 19 Nm |
- Tighten down screws (2) .
TIGHTENING TORQUES SPECIFICATION
| Vertical connection to deformation element | ||
|---|---|---|
| Flat-head screw M6x20 |
Tightening torque | 12 Nm |
Follow-up work
- Refer to PARTIALLY INSTALLING THE WIRING HARNESS FOR THE FRONT END .
- Refer to INSTALLING THE AIR DUCT AT THE BOTTOM .
- Refer to INSTALLING REINFORCEMENT STRUT .
- Refer to INSTALLING LEFT AND RIGHT BRAKE VENTILATION DUCT .
- Refer to INSTALLING THE LEFT AND RIGHT FANFARE HORN .
- Refer to INSTALLING THE BOTTOM AUTOMATIC AIR FLAP CONTROL .
- Refer to IF INSTALLED: INSTALLING FRONT RADAR SENSOR (FRS) WITH BRACKET .
- Refer to INSTALLING THE PEDESTRIAN PROTECTION SENSOR .
- Refer to INSERTING TOP AUTOMATIC AIR FLAP CONTROL .
- Refer to INSTALLING FRONT BUMPER COVER .
- Refer to INSTALLING CENTER RADIATOR GRILLE .
- Refer to INSTALLING THE CENTER ENGINE COMPARTMENT COVER .
- Refer to CONNECTING ALL BATTERY GROUND LEADS .
- Refer to ADJUSTING THE FRONT RADAR SENSOR (FRS) .
- Refer to ADJUSTING HEADLIGHTS .
- Refer to ACTIVATING THE 48 V ELECTRICAL SYSTEM .