Installing the air duct for coolant radiator
- Position air duct (2) .
- Hook wiring harness (1) into all the holders of air duct (2) .
- Clip wiring harness (1) into air duct (2) with the holders.
Follow-up work
- Refer to INSTALLING FRONT CROSS CONNECTION .
- Refer to INSTALLING UPPER CROSS CONNECTION .
- Refer to INSTALLING FRONT-END STRUT ON LEFT AND RIGHT .
- Refer to PREPARING THE SUPPORT FOR THE BUMPER COVER .
- Refer to INSTALLING THE SUPPORT FOR THE BUMPER COVER .
- Refer to INSTALLING SUPPORT FOR BUMPER COVER AT FRONT BOTTOM .
- Refer to FASTENING THE AIR DUCT FOR THE COOLANT RADIATOR TO THE SUPPORT FOR THE BUMPER COVER .
- Refer to INSTALLING INTAKE PORT .
- Refer to INSTALLING INTAKE FILTER HOUSING .
- Refer to INSTALLING LEFT AND RIGHT BRAKE VENTILATION DUCT .
- Refer to INSTALLING REINFORCEMENT STRUT .
- Refer to INSTALLING THE LEFT AND RIGHT FANFARE HORN .
- Refer to INSTALLING THE BOTTOM AUTOMATIC AIR FLAP CONTROL .
- Refer to INSTALLING THE PEDESTRIAN PROTECTION SENSOR .
- Refer to CONNECTING ALL BATTERY GROUND LEADS .
- Refer to IF INSTALLED: INSTALLING THE FRONT RADAR SENSOR (FRS) WITH THE BRACKET .
- Refer to INSERTING TOP AUTOMATIC AIR FLAP CONTROL .
- Refer to REPLACING UPPER ADAPTER FOR BUMPER TRIM PANEL .
- Refer to INSTALLING BUMPER COVER, FRONT .
- Refer to PARTIALLY INSTALLING THE TEMPERATURE SENSOR .
- Refer to PARTIALLY INSTALLING THE FRONT LEFT AND RIGHT WHEEL ARCH TRIM PANELS .
- Refer to INSTALLING COVERS AT FRONT BOTTOM ON LEFT AN RIGHT SIDES .
- Refer to INSTALLING FRONT UNDERBODY PROTECTION .
- Refer to INSTALLING THE COVER FOR CENTER ENGINE COMPARTMENT .
- Refer to INSTALLING THE FRONT HOOD SEAL .
- Refer to ACTIVATING THE 48 V ELECTRICAL SYSTEM .
- Refer to ADJUSTING HEADLIGHTS .