Replacing upper adapter for bumper trim panel
- Position the adapter (2) .
- Tighten the screws (1)
.TIGHTENING TORQUE SPECIFICATION
Adapter to the front panel Oval-head screw with spring washer tightening torque 4 Nm
Follow-up work
- Refer to INSTALLING BUMPER COVER, FRONT .
- Refer to PARTIALLY INSTALLING THE TEMPERATURE SENSOR .
- Refer to PARTIALLY INSTALLING THE FRONT LEFT AND RIGHT WHEEL ARCH TRIM PANELS .
- Refer to INSTALLING THE COVER FOR CENTER ENGINE COMPARTMENT .
- Refer to INSTALLING THE FRONT HOOD SEAL .