Installing the pedestrian protection sensor
NOTE:
Schematic diagram is for example purposes. Some parts may differ in certain details.
- Check impact absorber (2) for damage and replace if necessary.
- Carefully insert the pedestrian protection sensor (1)
into the impact absorber (2)
.
- Connect connectors (2) and lock.
- Hook the impact absorber into place below and press upwards.
- Secure expanding rivet (1) .
Follow-up work
- Refer to INSERTING TOP AUTOMATIC AIR FLAP CONTROL .
- Refer to REPLACING UPPER ADAPTER FOR BUMPER TRIM PANEL .
- Refer to INSTALLING BUMPER COVER, FRONT .
- Refer to PARTIALLY INSTALLING THE TEMPERATURE SENSOR .
- Refer to PARTIALLY INSTALLING THE FRONT LEFT AND RIGHT WHEEL ARCH TRIM PANELS .
- Refer to INSTALLING THE COVER FOR CENTER ENGINE COMPARTMENT .
- Refer to INSTALLING THE FRONT HOOD SEAL .
- Refer to RECONNECTING ALL BATTERY GROUND LEADS .
- Refer to ACTIVATING THE 48 V ELECTRICAL SYSTEM .