11 51 030 Removing and installing/replacing component carrier: Notes

WARNING: This page is about a different car, the 2018 BMW 340i, 2017 BMW 340i, and 2016 BMW 340i. However, it is still accessible from the selected car via links, so may be relevant.

WARNING: Vehicle may slip off the vehicle hoist if the vehicle hoist is handled incorrectly.
Danger! Immobilization period-threatening injuries!

Observe safety instructions on raising the vehicle using a vehicle hoist.
For additional information see: LIFTING THE VEHICLE USING A VEHICLE HOIST .

CAUTION: Materials harmful to health.
Contact with fluids harmful to health!

Note and follow safety instructions on containers.
Conduct all work in appropriate personal protective equipment only.

NOTE: Collect and dispose of emerging fluids. Observe country-specific waste disposal regulations.

NOTE: Notes on work at the cooling system form the basis of these repair instructions and must be complied with at all times.
For additional information see: INSTRUCTIONS FOR REPAIR WORK ON COOLING SYSTEM

Preliminary work

Refer to DISCONNECTING ALL BATTERY GROUND LEADS
Refer to REMOVING THE ACOUSTIC COVER
Refer to REMOVING INTAKE SILENCER HOUSING
Refer to REMOVING CLEAN AIR PIPE
Refer to REMOVING FAN COWL .
Refer to REMOVING CHARGE AIR LINE
Refer to REMOVING THE THROTTLE BODY
Refer to REMOVING THE DRIVE BELT FOR ALTERNATOR
Refer to REMOVING THE FRONT UNDERBODY PROTECTION
Refer to DRAINING THE COOLANT FROM THE HIGH-TEMPERATURE COOLING SYSTEM
Refer to REMOVING THE ALTERNATOR
Refer to UNINSTALLING COVER FOR THE DME CONTROL UNIT
Refer to REMOVING THE INTEGRATED POWER SUPPLY MODULE (PDM)
Refer to DISCONNECTING THE CONNECTOR FROM THE DME CONTROL UNIT AND FROM THE POWER DISTRIBUTION MODULE (PDM)
Refer to REMOVING THE DME CONTROL UNIT
Refer to REMOVING THE HOLDER FOR THE DIGITAL MOTOR ELECTRONICS-CONTROL UNIT
Suction the air conditioning. Refer to SUCTIONING AIR CONDITIONING SYSTEM (R134A) or SUCTIONING AIR CONDITIONING SYSTEM (R1234YF)
Refer to REMOVING AIR CONDITIONING COMPRESSOR

Follow-up work

Refer to INSTALLING AIR CONDITIONING COMPRESSOR
Refer to INSTALLING THE HOLDER FOR THE DIGITAL MOTOR ELECTRONICS-CONTROL UNIT
Refer to INSTALLING THE DME CONTROL UNIT
Refer to INSTALLING THE INTEGRATED POWER SUPPLY MODULE (PDM)
Refer to CONNECTING THE CONNECTOR TO THE DME CONTROL UNIT AND THE POWER DISTRIBUTION BOX (PDM)
Install cover for the DME control unit
Refer to INSTALLING THE ALTERNATOR
Refer to INSTALLING THE THROTTLE BODY
Refer to INSTALLING THE DRIVE BELT FOR ALTERNATOR
Refer to INSTALLING CHARGE AIR LINE
Refer to INSTALLING FAN COWL
Refer to INSTALLING CLEAN AIR PIPE
Refer to INSTALLING INTAKE SILENCER HOUSING
Refer to CONNECTING THE COOLANT HOSE TO THE RADIATOR
Refer to FILLING THE HIGH-TEMPERATURE COOLING SYSTEM WITH THE VACUUM FILLER DEVICE
Refer to INSTALLING ACOUSTIC COVER
Refer to CONNECTING ALL BATTERY GROUND LEADS
Refer to BLEEDING THE HIGH-TEMPERATURE COOLANT SYSTEM
Refer to FILLING AIR CONDITIONING SYSTEM (R134A) or FILLING AIR CONDITIONING SYSTEM (R1234YF) .
Install the front underbody protection