REP-TAT-P-1290-02 Installing the holder for the Digital Motor Electronics-control unit

WARNING: This page is about a different car, the 2018 BMW 340i, 2017 BMW 340i, and 2016 BMW 340i. However, it is still accessible from the selected car via links, so may be relevant.

Install the holder (2) for the Digital Motor Electronics control unit.
Tighten the screws (1).
TIGHTENING TORQUES SPECIFICATION

Digital Motor Electronics-control unit holder on spring strut dome 2.5 Nm

Courtesy of BMW OF NORTH AMERICA, INC.