REP-TAT-P-1371-02 Installing intake silencer housing
WARNING: This page is about a different car, the 2018 BMW 340i, 2017 BMW 340i, and 2016 BMW 340i. However, it is still accessible from the selected car via links, so may be relevant.
- Thread in and install intake silencer housing (3) into the intake port (4).
- Engage the intake filter housing (3) into the rubber mount.
- Tighten clamp (2).
TIGHTENING TORQUES SPECIFICATION
| Clean air pipe to intake silencer housing |
| Clamp |
3 Nm |
 Courtesy of BMW OF NORTH AMERICA, INC.
|
- Connect the connector (1) and audibly lock it.