11 14 005 Replacing front crankshaft seal: Notes
WARNING: This page is about a different car, the 2018 BMW 340i, 2017 BMW 340i, and 2016 BMW 340i. However, it is still accessible from the selected car via links, so may be relevant.
WARNING:
Hot surfaces.
Risk of burning!
Risk of burning!
- Perform all work only on components that have cooled down.
Preliminary work
- Refer to DISCONNECTING ALL BATTERY GROUND LEADS
- Refer to REMOVING THE FRONT UNDERBODY PROTECTION
- Refer to REMOVING THE REAR UNDERBODY PROTECTION
- Refer to REMOVING STARTER MOTOR
- Refer to REMOVING INTAKE SILENCER HOUSING
- Refer to REMOVING CLEAN AIR PIPE
- Refer to REMOVING FAN COWL .
- Refer to REMOVING THE DRIVE BELT FOR ALTERNATOR
- Refer to REMOVING THE VIBRATION DAMPER
Follow-up work
- Refer to INSTALLING THE VIBRATION DAMPER
- Refer to INSTALLING THE DRIVE BELT FOR ALTERNATOR
- Refer to INSTALLING FAN COWL
- Refer to INSTALLING CLEAN AIR PIPE
- Refer to INSTALLING INTAKE SILENCER HOUSING
- Refer to INSTALLING STARTER MOTOR
- Install underbody protection at rear
- Install the front underbody protection
- Refer to CONNECTING ALL BATTERY GROUND LEADS