Section 376 (Integrated Suspension Systems - Repair)
WARNING: This page is about a different car, the 2013 BMW X5, 2012 BMW X5, and 2011 BMW X5. However, it is still accessible from the selected car via links, so may be relevant.
- General
- 37 12 012 Carrying out ride height adjustment
- 37 00... Checking air springs for damage
- 00 Danger of poisoning if oil is ingested/absorbed through the skin
- 37 00 100 Draining/filling air spring system
- 37 00.. Notes on air spring system
- 37...... Overview of Dynamic Drive (ARS)
- 37...... Overview of Vertical Dynamics Management (VDM)
- 37...... Overview of ride-height control system
- 37..... Performing vertical acceleration sensor adjustment (vertical dynamics management)
- 00..... Raising vehicle with trolley jack
- 00 Risk of injury if oil comes into contact with eyes and skin
- 00 Safety information for working on vehicles with automatic engine start-stop function (MSA)
- 00 Safety instructions for handling oil
- 37 10 001 Start-up with test run of Dynamic Drive
- Front Control And Suspension Elements
- Rear Control And Suspension Elements
- 37 12 012 Carrying out ride height adjustment
- 37 00... Checking air springs for damage
- 37 12 001 Checking function of self-levelling suspension system
- 37 12 155 Removing and installing/replacing left or right air spring
- 37 12 220 Removing and installing/replacing rear active anti-roll bar
- 37 12... Replacing lower vent line for air supply unit
- 37 12... Replacing pipes for air springs
- 37 12... Replacing upper vent line for air supply unit
- Connecting Lines
- 37 13... Notes on fitting a new pipe or a screw connection
- 37 13... Removing and installing/replacing pressure line (middle) for oscillating motor/rear axle
- 37 13... Removing and installing/replacing pressure lines (front) for oscillating motor/front axle
- 37 13... Removing and installing/replacing pressure lines (front) for oscillating motor/rear axle
- 37 13... Removing and installing/replacing pressure lines (rear) for oscillating motor/front axle
- 37 13... Removing and installing/replacing pressure lines (rear) for oscillating motor/rear axle
- 37 13 100 Removing and installing/replacing pressure lines for oscillating motor/front axle
- 37 13 110 Removing and installing/replacing pressure lines for oscillating motor/rear axle
- 32 41... Replacing return line for Dynamic Drive (M57T2)
- Electrical Components
- 37 14 610 Removing and installing/replacing lateral acceleration sensor
- 34 52 550 Removing and installing/replacing DSC rotation-rate sensor
- 37 14 055 Removing and installing/replacing DYNAMIC DRIVE control unit
- 61 36 540 Removing and installing/replacing air supply unit relay
- 37 14 525 Removing and installing/replacing control unit for air supply unit
- 37 15... Removing and installing/replacing control unit for vertical dynamics management
- 37 14 521 Replacing front left ride-height sensor
- 37 14 511 Replacing front right ride-height sensor
- 37 14 515 Replacing rear left or right ride-height sensor
- 37 10 001 Start-up with test run of Dynamic Drive
- Electronic Damping Force Adjustment
- Pump Assembly With Container