Installing the right engine mount

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2023 BMW X2, 2022 BMW X2, 2021 BMW X2, 2020 BMW X2, and 2019 BMW X2. However, it is still accessible from the selected car via links, so may be relevant.

Insert and install the engine mount (1) in the direction of the arrow.

Courtesy of BMW OF NORTH AMERICA, INC.
Tighten down screw (1).

TIGHTENING TORQUE SPECIFICATIONS

Right engine mount to side member
M12	Tightening torque	100 Nm

Courtesy of BMW OF NORTH AMERICA, INC.

Tighten down screw (3).

TIGHTENING TORQUE SPECIFICATIONS

Right engine mount to side member
M12	Tightening torque	100 Nm

Insert and install the coolant line (2).
Lock holder (1).
Make sure the holder (1) engages audibly.

Courtesy of BMW OF NORTH AMERICA, INC.

Tighten the screws (1).

TIGHTENING TORQUE SPECIFICATIONS

Right engine mount to cylinder head
M10 Replace screws.	Joining torque	40 Nm
M10 Replace screws.	Angle of rotation	90°

Courtesy of BMW OF NORTH AMERICA, INC.

Insert and install the coolant line (4).
Tighten down screw (3).

TIGHTENING TORQUE SPECIFICATIONS

Refrigerant line to engine mount
M6	Tightening torque	8 Nm

Courtesy of BMW OF NORTH AMERICA, INC.

Insert and install the partition panel (2).
Tighten down screw (1).

TIGHTENING TORQUE SPECIFICATIONS

Partition panel to engine mount
screw	Tightening torque	3 Nm

Insert and install a new sealing ring (1) on the coolant line (2).

Courtesy of BMW OF NORTH AMERICA, INC.
Insert and install the coolant line (4).
Tighten down screw (3).

TIGHTENING TORQUE SPECIFICATIONS

Connection point of intake pipe T1 to intake pipe T2
M6X25	Tightening torque	8 Nm

Lock holder (2).
Make sure the holder (2) engages audibly.
Fasten the holder (1) on the coolant line (4).

Courtesy of BMW OF NORTH AMERICA, INC.
Disassemble the special tool 2 414 691 with the special tool 2 357 071 .

Courtesy of BMW OF NORTH AMERICA, INC.

Follow-up work

Refer to INSERTING FILLING HOSE OF THE WASHER FLUID RESERVOIR .
Refer to INSTALLING THE FRONT UNDERBODY PROTECTION .
Refer to INSTALLING THE SERVOMOTOR FOR THE ECCENTRIC SHAFT .
Refer to INSTALLING THE FRONT RIGHT WHEEL ARCH COVER .
Refer to INSTALLING THE FRONT RIGHT WHEEL .
Refer to FILLING THE AIR CONDITIONING .
Refer to INSTALLING INTAKE SILENCER HOUSING .
Refer to INSTALLING THE INTAKE MANIFOLD FOR THE INTAKE FILTER HOUSING .
Refer to INSTALLING THE UPPER FIREWALL COVER PANEL .
Refer to INSTALLING THE STRUT BRACE .
Refer to INSTALLING THE FRONT UNDERBODY PROTECTION .
Refer to INSTALLING ACOUSTIC COVER .