Removing the grooved ball bearing in the propeller shaft center bearing
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2023 BMW X2, 2022 BMW X2, 2021 BMW X2, 2020 BMW X2, and 2019 BMW X2. However, it is still accessible from the selected car via links, so may be relevant.
- Install the special tool 0 490 482 (00 7 500) between the grooved ball bearing (1) and the prop shaft (2) .
- Push the grooved ball bearing (1) off with the help of the hydraulic press from the prop shaft (2) .
Follow-up work
- Refer to INSTALLING THE PROPELLER SHAFT CENTER BEARING .
- Refer to INSTALLING PROP SHAFT .
- Refer to INSTALLING THE REAR HEAT SHIELD .
- Refer to INSTALLING FRONT HEAT SHIELD .
- Refer to INSTALLING EXHAUST SYSTEM .
- Refer to INSTALLING THE CROSS-MEMBER WITH TORSION STRUTS .
- Refer to INSTALLING THE CONNECTING SUPPORT ON THE TUNNEL AT FRONT AND REAR .
- Refer to INSTALLING UNDERBODY PROTECTION AT REAR .