Install brake booster
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2023 BMW X2, 2022 BMW X2, 2021 BMW X2, 2020 BMW X2, and 2019 BMW X2. However, it is still accessible from the selected car via links, so may be relevant.
- Guide the brake booster (1)
into the firewall.
- Replace nuts (1)
.
Parts: Nuts
- Install the nuts (1) and tighten.
TIGHTENING TORQUE SPECIFICATIONS
| Brake booster to pedal assembly console Replace nuts . | ||
| M8 Replace nuts. |
Tightening torque | 24 Nm |
- Install the retaining bolt (1)
through the brake pedal.
Lightly grease the retaining bolt (1) .
- Replace the retaining clip (2)
.
Parts: Retaining clip
- Mount the retaining clip (2) on the retaining bolt.
Follow-up work
- Refer to INSTALLING CONSOLE FOR WINDSHIELD WIPER SYSTEM COMPLETE WITH MOTOR .
- Refer to INSTALLING THE REAR COWL PANEL .
- Refer to INSTALLING THE GUTTER STRIP ON THE WINDSCREEN ON THE LEFT AND RIGHT .
- Refer to INSTALLING LEFT AND RIGHT WIPER ARM .
- Refer to PREPARATIONS FOR INSTALLING THE TANDEM BRAKE MASTER CYLINDER .
- Refer to INSTALLING THE TANDEM BRAKE MASTER CYLINDER .
- Refer to INSTALLING THE EXPANSION TANK .
- Refer to INSTALLING THE SYSTEM BATTERY .
- Refer to INSTALLING INTAKE SILENCER HOUSING .
- Refer to INSTALLING THE INTAKE MANIFOLD FOR THE INTAKE FILTER HOUSING .
- Refer to INSTALLING THE STRUT BRACE .
- Refer to CONNECTING BATTERY GROUND LEAD .
- Refer to CONNECTING THE BRAKE FLUID BLEEDER UNIT (AFTER REPAIR) .
- Refer to FLUSHING AND BLEEDING THE REAR AXLE BRAKE CIRCUIT .
- Refer to FLUSHING AND BLEEDING THE FRONT AXLE BRAKE CIRCUIT .
- Refer to DISCONNECTING THE BLEEDER UNIT FOR THE BRAKE FLUID (AFTER REPAIR) .
- Refer to INSTALLING FRONT WINDSHIELD PANEL COVER .
- Refer to INSTALLING THE REAR HOOD SEAL .