Overview - Clutch Housing
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2024 Audi SQ5, 2024 Audi Q5 e, 2024 Audi Q5, 2023 Audi SQ5, and 2023 Audi Q5 e. However, it is still accessible from the selected car via links, so may be relevant.
- Clutch Housing
- Pinion
- Removing and Installing. Refer to PINION, REMOVING AND INSTALLING .
- Disassembling and Assembling. Refer to DRIVE PINION, DISASSEMBLING AND ASSEMBLING .
- Adjusting. Refer to PINION, ADJUSTING .
- Alignment Sleeve
- Quantity: 2
- Parking Lock Gear
- Spur Gear Unit Output Gear
- Circlip
- Replace after removing
- Selecting thickness. Refer to Figure.
- Oil Guide Shell
- Vehicles without self-locking center differential: replace after removal of the roller bearing for the output shaft.
- Inner Output Shaft
- Only on vehicles with self-locking center differential
- With drive wheel for spur gear unit, ball bearing and bearing shell
- Removing and Installing. Refer to Inner Output Shaft Roller Bearing, Removing, Vehicles with Self-Locking Center Differential .
- Disassembling and Assembling. Refer to INNER OUTPUT SHAFT, DISASSEMBLING AND ASSEMBLING, ONLY VEHICLES WITH SELF-LOCKING CENTER DIFFERENTIAL .
- Bolt
- Quantity: 3
- Replace after removing
- 5 Nm + 120°
- Output Shaft Roller Bearing
- Bearing "H"
- Replacing. Refer to Output Shaft Roller Bearing, Replacing, Vehicles without Self-Locking Center Differential .
- Bearing Shell
- Bolts
- Quantity: 2
- 5 Nm + 30°
- Circlip
- Input Shaft Needle Bearing
- Bearing "B"
- Installation position: labeling of the bearing (thicker wall thickness) points to the circlip
- Replacing. Refer to Drive Axle Bearing, Replacing .
- Guide Sleeve
- Installation position: the open side points to the dual clutch
- Seal
- For the input shaft
- Replace after removing
- Removing and Installing. Refer to INPUT SHAFT SEAL, REPLACING, CLUTCH HOUSING .