LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2016 >> S5 Prestige, 2D Convertible >> Repair and Diagnosis >> External Pages >> Different car >> Section 4 (3.0L - Engine Mechanical, Engine Code(S): AVK, BGN) >> 26 Exhaust system, Emission controls >> Exhaust system, servicing >> Right front exhaust pipe with catalytic converter, removing and installing (vehicles with automatic transmission 01V) >> Installing

Right front exhaust pipe with catalytic converter, removing and installing (vehicles with automatic transmission 01V): Installing

WARNING: This page is about a different car, the 2006 Audi A4, 2005 Audi A4, 2004 Audi A4, 2003 Audi A4, and 2002 Audi A4. However, it is still accessible from the selected car via links, so may be relevant.

Installation is reverse of removal, noting the following:

NOTE:
  • All cable ties opened or cut during engine removal must be reinstalled at the same locations during installation.
  • Oxygen sensor threads are coated with an assembly paste. This paste must not contact sensor openings.
  • Oxygen sensor wiring must always be secured in the same position when installing so that contact with the exhaust pipe is avoided.
  • Replace gaskets and self-locking nuts.

Refer to

Refer to 40 - FRONT SUSPENSION

Refer to 40 - FRONT SUSPENSION

Refer to

Refer to

NOTE: Individual mounting components for exhaust system to transmission on vehicles with automatic transmission 01V. See Figure.

Refer to

scientia non olet · About LEMON Manuals