Section 61 (Differential System (General & Service Information - Rear Final Drive 0B5A, 0BKA Sport Differential))
WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2018 Audi S7, 2018 Audi RS 7, 2018 Audi A7 Quattro, 2017 Audi S7, and 2017 Audi RS 7. However, it is still accessible from the selected car via links, so may be relevant.
- Final Drive, Differential
- Driveshaft, Removing And Installing From Rear Final Drive
- Overview - Driveshaft, Mounted On Transmission Side
- Electrical/Electronic Components And Component Locations
- Overview - Rear Final Drive
- Rear Final Drive, Disassembling And Assembling
- Hydraulic Control Unit, Removing And Installing
- Hydraulic Control Unit, Disassembling And Assembling
- All Wheel Drive Pump -V415-, REMOVING AND INSTALLING
- Oil Pressure/Temperature Sensor -G437- OR Oil Pressure/Temperature Sensor 2 -G640-, REMOVING AND INSTALLING
- All Wheel Drive Clutch Valve -N445- OR All Wheel Drive Clutch Valve 2 -N446-, REMOVING AND INSTALLING
- Torque Displacement, Checking
- Rear Final Drive, Removing And Installing
- Gear Oil And ATF, In Rear Final Drive
- Notes
- Overview - Drain And Inspection Plug For ATF And Gear Oil, Rear Final Drive 0BF And 0BE
- Gear Oil Level In Rear Final Drive 0BF And 0BE, Checking
- Gear Oil On Rear Final Drive 0BF And 0BE, Draining
- Gear Oil In Rear Final Drive 0BF, Filling
- Gear Oil In Rear Final Drive 0BE, Filling
- ATF Level In Rear Final Drive 0BF And 0BE, Checking
- ATF On Rear Final Drive 0BF And 0BE, Draining
- ATF On Rear Final Drive 0BF And 0BE, Filling
- Flange Shaft Seals, Replacing, Rear Final Drive Removed
- Shaft Seal For Flange/PROPSHAFT, Replacing
- Special Tools