All Wheel Drive Pump -V415-, REMOVING AND INSTALLING: Removing
WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2018 Audi S7, 2018 Audi RS 7, 2018 Audi A7 Quattro, 2017 Audi S7, and 2017 Audi RS 7. However, it is still accessible from the selected car via links, so may be relevant.
-- Place the vehicle on a lift.
- The ignition is off.
-- Place the Drip Tray under the rear final drive.
-- Disconnect the connector -1- from the All Wheel Drive Pump -V415- -2-.
-- Remove the four bolts that connect the All Wheel Drive Pump -V415- to the hydraulic control unit using the Hex Ball Socket :T10058 .
-- Carefully remove the All Wheel Drive Pump -V415- -2-. Pay close attention to the adapter -item 4- HYDRAULIC CONTROL UNIT, DISASSEMBLING AND ASSEMBLING inside the hydraulic pump while doing this.
NOTE:
The adapter could fall out when removing the All Wheel Drive Pump -V415-.
Insert the adapter into the recesses in the hydraulic pump before installing the All Wheel Drive Pump -V415-.