Flange/Driveshaft Seal, Replacing
WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2018 Audi S7, 2018 Audi RS 7, 2018 Audi A7 Quattro, 2017 Audi S7, and 2017 Audi RS 7. However, it is still accessible from the selected car via links, so may be relevant.
Special tools and workshop equipment required
- Bearing/Bushing Installer - Multiple Use :VW295A
- Press Plate :VW402
- Press Piece - Rod :VW408A
- Support Channels :VW457
- Separating tool 22 to 75 mm, such as Puller - Kukko Quick Action Separating Tool - 12-75 mm :17/1
B - Separating Tool - 12-75 mm, such as Puller - Kukko Quick Action Separating Tool - 12-75 mm :17/1
- The ridge -arrow 1- on the protective ring -A- must fit into the groove -arrow 2- on the flange -B-. The smaller outer circumference -arrow 3- faces the flange.
- The protective ring -A- must fit into the groove all around the flange. Refer to the figure above.