ATF Level In Rear Final Drive 0BF And 0BE, Checking
WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2018 Audi S7, 2018 Audi RS 7, 2018 Audi A7 Quattro, 2017 Audi S7, and 2017 Audi RS 7. However, it is still accessible from the selected car via links, so may be relevant.
Test Requirement
- ATF temperature: 10 °C to 60 °C (50 °F to (140 °F)
- The rear final drive must be in the installed position.
- The vehicle must be level.
Special tools and workshop equipment required
- Drip Tray
-- Remove the ATF check plug -1- to check the ATF level.
CAUTION:
- The ATF check plug -1- is located on the left side of the rear final drive. Identification >>ATF<< on the final drive housing -arrow-
- ATF sealing plug overview. Refer to OVERVIEW - DRAIN AND INSPECTION PLUG FOR ATF AND GEAR OIL, REAR FINAL DRIVE 0BF AND 0BE .
- The ATF level is correct when the rear final drive is filled to the lower edge of the fill hole.
If the ATF is correct:
-- Install the new ATF check plug and fasten. Tightening specification -item 12- OVERVIEW - REAR FINAL DRIVE.
If the ATF is not correct:
-- Fill with ATF. Refer to ATF ON REAR FINAL DRIVE 0BF AND 0BE, FILLING .