Front final drive, assembly overview

1 - Oil seal

• Between final drive and transmission housing
• Replacing → Final drive/transmission housing oil seal, replacing 

2 - Shim

• Behind tapered roller bearing outer race

3 - Tapered roller bearing outer race

4 - O-ring

• Always replace

5 - Sealing plug, 35 Nm

• Always replace

6 - Flange shaft, right

• Removing and installing → Right flange shaft, removing and installing 

7 - Circlip

• Always replace

8 - Right flange shaft oil seal

• Replacing → Right flange shaft seal, replacing 

9 - Bolt -23 Nm

• Observe tightening sequence → Final drive cover O-ring, replacing 

10 - Cover for final drive

11 - Shim

• Behind tapered roller bearing outer race

12 - Tapered roller bearing outer race

13 - O-ring for final drive cover

• Replacing → Final drive cover O-ring, replacing 

14 - Differential

15 - Spring pin

16 - Selector shaft lever

17 - Selector shaft seal

• Replacing → Selector shaft oil seal, replacing 

18 - Bolt -23 Nm

19 - Flange shaft, left

• Removing and installing → Left flange shaft, removing and installing