Right flange shaft seal, replacing
WARNING: This page is about a different variant/trim than selected.
NOTE:
- General repair instructions → Repair instructions .
- Observe rules for cleanliness when working on automatic transmission → Rules for cleanliness when working on automatic transmission .
Special tools, testers and auxiliary items required
- Drip tray V.A.G 1306
- Extractor lever VW 681
- Thrust piece T10138
Removing
- Place drip tray V.A.G 1306 under transmission.
- Remove right flange shaft → Right flange shaft, removing and installing .
- Remove flange shaft oil seal.
Installing
- Coat outer circumference of seal with gear oil.
- Drive new seal in as far as the stop; do not distort seal.
- Installation position: The open side of the seal faces transmission.
- Half fill space between sealing lip and dust lip with sealing grease G 052 128 A1 .
- Install right flange shaft → Right flange shaft, removing and installing .
- Check oil level in front final drive → Front final drive gear oil .