Venting the Boot

WARNING: This page is about a different car, the 2002 Volvo C70, 2001 Volvo C70, 2000 Volvo C70, 1999 Volvo C70, and 1998 Volvo C70. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Inserting Screwdriver Between Drive Shaft And Gaiter

Courtesy of VOLVO CARS OF NORTH AMERICA.

Venting is carried out to remove any over pressure in the boot.

Use a rounded screwdriver.

Carefully insert the screwdriver between the drive shaft and boot. Ensure that the boot is in position on the drive shaft. Install the inner clamp. Use pliers 9512619 .

NOTE: Install the drive shaft on the transmission. See Install the Drive Shaft To the Stub Axle

Install the drive shafts

Left side, see Install the Drive Shaft And Stub Axle .

Right side, see Install the Drive Shaft To the Stub Axle .