Install the Drive Shaft To the Stub Axle
WARNING: This page is about a different car, the 2002 Volvo C70, 2001 Volvo C70, 2000 Volvo C70, 1999 Volvo C70, and 1998 Volvo C70. However, it is still accessible from the selected car via links, so may be relevant.
Position the mobile jack as a support under the control arm.
Align the drive shaft in the hub
Lubricate the shaft splines using grease, P/N 116 1246-2.
Install:
- the new screws for the stub axle. Use new lock nuts. Tighten to 90 Nm
- counterhold
- the drive shaft nut. Lubricate the nut before installation. Tighten. See Center Nut, Drive Shaft And Tightening Torque
.
Remove the counterhold.