Transmission Input Speed Sensor -G182- AND Transmission Output Speed Sensor -G195-, REMOVING AND INSTALLING

WARNING: This page is about a different car, the 2023 Volkswagen Atlas. However, it is still accessible from the selected car via links, so may be relevant.

-- Remove the valve body. Refer to VALVE BODY, REMOVING AND INSTALLING .

-- Remove the bolt -1- from the Transmission Output Speed Sensor -G195-.

Fig 1: Transmission Input Speed Sensor -G182- and Transmission Output Speed Sensor -G195-

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Remove the bolt -2- from the Transmission Input Speed Sensor -G182-.

-- Remove the sensor from the transmission housing.

Install in reverse order of removal while noting the following:

-- Press the sensor all the way into the transmission housing.

-- Tighten the bolt -1 or 2-. Refer to OVERVIEW - VALVE BODY for the tightening specification.

-- Install the valve body. Refer to VALVE BODY, REMOVING AND INSTALLING .

-- Install the transmission fluid screen. Refer to TRANSMISSION FLUID SCREEN, REMOVING AND INSTALLING .

-- Install the transmission fluid pan. Refer to TRANSMISSION FLUID PAN, REMOVING AND INSTALLING .

-- Fill the ATF, and check the ATF level and add ATF if necessary. Refer to ATF, DRAINING AND FILLING .