LEMON Manuals: Even more car manuals for everyone
Home >> Volkswagen >> 2017 >> Golf S, Eng CD CXBA, Standard Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 21 (Engine System (Crankshaft & Cylinder Block - Service Information - CRUA)) >> 13 Crankshaft, Cylinder Block >> Cylinder Block, Belt Pulley Side >> Overview - Cylinder Block, Belt Pulley Side >> Notes

Overview - Cylinder Block, Belt Pulley Side: Notes

WARNING: This page is about a different car, the 2015 Volkswagen Golf. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Exploded View Of Cylinder Block, Belt Pulley Side Components
GWWA13-10923
  1. Ribbed Belt
    • Check for wear
    • Before removing, mark the running direction using chalk or a felt-tip pen.
    • Do not kink
    • Ribbed belt routing. Refer to Installing .
    • Removing and installing. Refer to RIBBED BELT, REMOVING AND INSTALLING .
    • When installing, make sure it is seated correctly on the belt pulleys
  2. Bolt
    • 10 Nm + 90°
    • Always replace after removing.
    • Use original bolts only.
  3. Vibration Damper
    • With the ribbed belt pulley
    • Installation position: The hole inside the vibration damper must be positioned over the raised section on the crankshaft toothed belt sprocket.
    • Removing and installing. Refer to VIBRATION DAMPER, REMOVING AND INSTALLING .
  4. Ribbed Belt Tensioner
  5. Bolt
    • 20 Nm + 90°
    • Always replace after removing.
  6. Bolt
  7. Bolt
  8. Damper Roller
  9. Alignment Sleeve
    • Make sure the sub-assembly bracket fits correctly.
  10. Sub-Assembly Bracket
  11. High Pressure Pump
  12. Generator
  13. Bolt
  14. Bolt
  15. Alignment Sleeve
    • Make sure it is seated correctly inside the A/C compressor.
  16. A/C Compressor
  17. Bolt
scientia non olet · About LEMON Manuals