Sub-Assembly Bracket - Tightening Specifications And Sequence
WARNING: This page is about a different car, the 2015 Volkswagen Golf. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
Replace the bolts that were tightened with an additional turn after removing them.
-- Install the bolts as follows:
- M10x35 bolts -1, 2, 3 and 6- .
- M10x115 bolt -4- .
- M10x175 bolt -5- .
-- Tighten the bolts in the steps shown in the sequence:
| Step | Bolts | Tightening Specification/Additional Turn |
|---|---|---|
| 1. | -1 to 6- | Install by hand all the way |
| 2. | -1 to 6- | 40 Nm |
| 3. | -4 and 5- | 180° additional turn |
| 4. | -1, 2, 3 and 6- | 45° additional turn |