LEMON Manuals: Even more car manuals for everyone
Home >> Volkswagen >> 2017 >> Golf S, Eng CD CXBA, Standard Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 14 (Differential System (Service Information - 6-Speed Dual Clutch Transmission - 0D9)) >> 39 Final Drive, Differential >> Bevel Box Components >> Overview - Bevel Box Components

Overview - Bevel Box Components

WARNING: This page is about a different car, the 2017 Volkswagen GTI, 2016 Volkswagen GTI, 2015 Volkswagen Golf, and 2015 Volkswagen GTI. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Exploded View Of Bevel Box Components
GWWA39-10228Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.
  1. Nut
    • 480 Nm
    • Replace after removing
  2. Bevel Box Output Flange
  3. Output Flange Cover Cap
    • Only replace if damaged
  4. Seal
  5. Seal
  6. Bevel Box
  7. Oil Drain Plug
    • M6 bolt: 15 Nm
    • M8 bolt: 60 Nm
    • For bevel box
  8. Seal
  9. Fill and Check Plug
    • 15 Nm
    • Always replace after removing
    • For bevel box
  10. Bolt
    • Always replace after removing
    • Tightening Specification. Refer to OVERVIEW - BEVEL BOX .
    • Affix bevel box to transmission
    • Quantity: 4
  11. Bleed Pipe
  12. Bleed Cap
  13. Bolt
  14. Right Flange Shaft
  15. Seal
    • Replace after removing the right flange shaft
  16. Bearings
    • The needle bearings (polygon bearings) are difficult to move when the flange shaft is removed. Difficulty in movement is not an indication of faulty bearings. A test for noisy bearings can only be performed with the bearings installed.
    • Check for damage on the bearing, for example, cracks on outer race.
    • Refer to RIGHT FLANGE SHAFT NEEDLE BEARING (POLYGON BEARING), REPLACING 
  17. Bearings
    • The needle bearings (polygon bearings) are difficult to move when the flange shaft is removed. Difficulty in movement is not an indication of faulty bearings. A test for noisy bearings can only be performed with the bearings installed.
    • Check for damage on the bearing, for example, cracks on outer race.
    • Replacing. Refer to RIGHT FLANGE SHAFT NEEDLE BEARING (POLYGON BEARING), REPLACING .
  18. Circlip
    • Replace after removing