Transmission Housing And Shift Mechanism
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2010 Volkswagen Jetta, 2009 Volkswagen Jetta, 2008 Volkswagen Jetta, 2007 Volkswagen Jetta, and 2006 Volkswagen Jetta. However, it is still accessible from the selected car via links, so may be relevant.
- Bolt
- 25 Nm
- Flange Shaft with Pressure Spring
- Removing and installing, refer to one of the following:
- Assembling, refer to DIFFERENTIAL .
- Bolt
- 25 Nm
- For the reverse shaft support.
- Self locking.
- Always replace.
- Bolt
- 30 Nm
- For the reverse shaft support.
- Self locking
- Always replace.
- O-ring
- Always replace
- Pivot Pin
- Bolt
- 25 Nm
- Bolt
- 25 Nm
- Sealing Cap
- Bolt
- 25 Nm
- For the reverse shaft support.
- Always replace.
- Bolt
- 5 Nm
- Transmission Neutral Position Sensor -G701-
- For vehicles with the start/stop system.
- Transmission Housing
- Remove together with 5th gear, refer to TRANSMISSION .
- Disassembling and assembling, refer to TRANSMISSION HOUSING AND CLUTCH HOUSING .
- Clutch Housing
- Disassembling and assembling, refer to TRANSMISSION HOUSING AND CLUTCH HOUSING .
- Bolt
- 25 Nm + 90° (1/4) additional turn.
- Always replace.
- Selector Lever with Selector Cover
- (Shift unit)
- Disassembling and Assembling, refer to SHIFT UNIT .
- Bolt
- 25 Nm