Section 18 (Brake System - A4 Platform)
WARNING: This page is about a different variant/trim than selected.
- 00 General, Technical Data
- 45 Anti-Lock Brake System
- Anti-lock brake system (ABS) and anti-lock brake system with electronic differential lock (ABS/EDL) ITT Mark 20 IE
- Hydraulic unit, brake booster/master cylinder, overview
- ABS system components for front axle, removing and installing
- Anti-lock brake system (ABS) Mark 60
- VAS 5051 Vehicle Diagnostic, Testing and Information System, connecting and selecting functions
- Electrical/electronic components and installing locations (ABS) Mark 60
- Hydraulic unit, brake booster/brake master cylinder Mark 60, assembly overview
- DTCs displayed by (ABS) Mark 60 warning lights -K32-, -K47-, -K118-, and -K155-
- ABS system components for front and rear axles, removing and installing
- ESP system components, removing and installing
- ESP system components, removing and installing
- Sender for rotation rate -G202- and sensor for transverse acceleration -G200-, removing and installing
- Longitudinal acceleration sensor -G251-, removing and installing
- ESP sensor unit -G419-, vehicles from my 02.02, removing and installing
- Steering angle sensor -G85-, removing and installing
- 46 Brakes - Mechanical Components
- Front brakes
- Rear wheel brakes (disc brakes - front wheel drive), assembly overview
- Rear wheel brakes/disc brakes (all-wheel drive), servicing
- Parking brake cables for disc brakes - front wheel drive, removing and installing
- Parking brake cables for disc brakes - all wheel drive, removing and installing
- Parking brake lever, assembly overview
- Brake pedal - assembly overview
- 47 Brakes - Hydraulic Components
- Front brake calipers, servicing
- FN 3 front brake calipers, servicing
- Rear brake caliper, servicing
- Brake pressure regulator, assembly overview
- Brake system, bleeding
- Brake system, bleeding
- Bleeding brake system with brake filler and bleeder unit VAS 5234, vehicles with ABS Mark 20
- Brake system, bleeding without pressure bleeder
- Bleeding brake system with brake filler and bleeder unit VAS 5234, vehicles with ABS Mark 60
- Bleeding brake system without brake filling and bleeding appliance
- Brake booster/brake master cylinder for vehicles with ABS/EDL/ASR/ESP, servicing for vehicles up to my 10.00
- Brake booster/brake master cylinder for vehicles with ABS/EDL/ASR/ESP Mark 60 from m.y. 10.00, assembly overview
- Brake booster/brake master cylinder for vehicles with ABS/EDL/ASR/ESP Mark 60 from m.y. 10.00, assembly overview
- Sender 1 for brake booster -G201- and Sensor -2- for brake pressure -G214-, removing and installing
- Check function of brake assist in brake booster, vehicles from my 02.02,
- Brake system vacuum pump -V192-, removing and installing
- Brake system vacuum pump -V192-, checking
- Brake booster pressure sensor -G294-, removing and installing
- Check function of check valve -A-.
- Brake system vacuum pump -V192-, vehicles up to my 05.02, electrical check
- Multi-pin connector with contact assignment
- Test table (test steps 1 - 6)
- Brake system vacuum pump -V192-, vehicles from my 06.02, electrical check
- Test table (test steps 1 - 4)
- Brake master cylinder, removing and installing
- Brake booster, removing and installing
- Definitions