Brake system vacuum pump -V192-, removing and installing

WARNING: This page is about a different variant/trim than selected.

There are no provisions for servicing the brake system vacuum pump -V192-. If a malfunction is detected the brake vacuum pump -V192- must be replaced.

The brake system vacuum pump -V192- is located lower left on the subframe.

Removing

Fig 1: Identifying Brake System Vacuum Pump Bracket Bolts & Brake System Vacuum Pump Hose

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Remove bolts -1- on bracket for brake system vacuum pump -V192-.
Pull hose (arrow) off brake system vacuum pump -V192-.
Take out brake system vacuum pump -V192-.

Fig 2: Identifying Brake System Vacuum Pump Bracket & Fasteners

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Bracket (arrow) for brake system vacuum pump -V192-.

Remove lock nut -2- from bolt -1-.
Remove bolt -4-.
Take bracket out.
Remove bolts -3- to disassemble the bracket (arrow) further.

Installing

Install in reverse order.

Fig 3: Identifying Brake System Vacuum Pump Bracket & Fasteners

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Tightening torques

Nut -2- to bracket	20 Nm	(15 ft. lb)
Bolts -3- to bracket	8 Nm	(71 in. lb)
Bolt -4- to bracket	20 Nm	(15 ft. lb)
Torx socket head bolt for brake vacuum pump -V192- to bracket	8 Nm	(71 in. lb)