Leak Detection Pump (LDP) and EVAP canister (vehicles with engine code BJS), removing and installing: Notes

WARNING: This page does not describe the selected car, but rather 14 other vehicles, including the 2005 Volkswagen GTI, 2004 Volkswagen R32, 2004 Volkswagen Jetta, 2004 Volkswagen GTI, and 2003 Volkswagen Jetta. However, it is still accessible from the selected car via links, so may be relevant.

Leak Detection Pump (LDP) -V144- is installed in right rear wheel housing. It is connected with its ventilation lines on Evaporative Emission (EVAP) Canister Purge Regulator Valve -N80- in engine compartment, right side, and on EVAP canister.

EVAP canister is installed from below on the vehicle floor in the vicinity of the spare wheel well.

Removing and installing Leak Detection Pump (LDP) -V144-. Refer to Leak Detection Pump (LDP) -V144-, removing and installing .

Removing and installing EVAP canister. Refer to EVAP canister, removing and installing .

Recommended special tools and equipment

Fig 1: Special Tool - Torque Wrench V.A.G 1331

Courtesy of VOLKSWAGEN UNITED STATES, INC.

V.A.G 1331 torque wrench (5 to 50 Nm)