EVAP canister, removing and installing
WARNING: This page does not describe the selected car, but rather 14 other vehicles, including the 2005 Volkswagen GTI, 2004 Volkswagen R32, 2004 Volkswagen Jetta, 2004 Volkswagen GTI, and 2003 Volkswagen Jetta. However, it is still accessible from the selected car via links, so may be relevant.
- Remove rear muffler (Refer to Muffler with mounts (vehicles with engine codes BJS) , item 9).
- Unscrew rear muffler heat shield from vehicle floor.
- Now unscrew the right and left stabilizer bearing from vehicle floor.
- Remove cover beneath EVAP canister (Refer to Parts of EVAP canister system (vehicles with engine code BJS), removing and installing , item 11).
- Disconnect 2-pin connector -1- from Evaporative Emission (EVAP) Canister Purge Solenoid Valve -N115-.
- Unscrew studs -arrows- and remove EVAP canister.
- Installation of EVAP canister is the same in reverse order.
While installing, make sure that ventilation lines are connected securely and are not kinked.