List of selectable functions
WARNING: This page is about a different variant/trim than selected.
| Reference | ||
| 00 - | Automatic test sequence | Automatic test sequence |
| 01 - | Check control module version. Refer to Connecting V.A.G 1551 scan tool and selecting function | V.A.G 1551 scan tool, connecting and selecting function |
| 01 - | Check control module version. Refer to Connecting tester VAS 5051 and selecting function | Vehicle Diagnosis, Testing and Information System VAS 5051, connecting and selecting ABS control module |
| 02 - | Check Diagnostic Trouble Code (DTC) memory | Diagnostic Trouble Code (DTC) memory, checking |
| 03 - | Output Diagnostic Test Mode (DTM) | Output Diagnostic Test Mode (DTM) |
| 04 - | Initiate basic setting | Basic setting, initiating |
| 05 - | Erase DTC memory | Diagnostic Trouble Code (DTC) memory, erasing and ending output |
| 06 - | End output | Diagnostic Trouble Code (DTC) memory, erasing and ending output |
| 07 - | Code control module | ABS control module, coding |
| 08 - | Read measured value block | Measured value block, reading |
| 11 - | Login procedure | Login procedure |