Login procedure
WARNING: This page is about a different variant/trim than selected.
- All functions that have so far been carried out with V.A.G 1551 can now also be carried out with the tester VAS 5051.
- The login procedure can only be performed once per calibration.
Coding is only possible after the workshop code (WSC) has been introduced into V.A.G 1551 or the new tester VAS 5051.
Test sequence
- Connect V.A.G 1551 scan tool and select (address word 03) brake electronics control module with ignition switched on; Refer to V.A.G 1551 scan tool, connecting and selecting function .
Indicated on display:
| Rapid data transfer HELP Enter address word XX |
- Press key 1 and 1 (Function "Login procedure" is introduced with 11).
Indicated on display:
| Rapid data transfer Q 11 Coding 2 |
- Confirm entry with key Q.
Indicated on display:
| Coding 2 HELP Enter code number XXXXX |
- Enter code number 40168.
- Confirm entry with key Q.
Indicated on display:
| Rapid data transfer HELP Select function XX |