Diagnostic Trouble Code (DTC) memory, checking
WARNING: This page is about a different variant/trim than selected.
NOTE:
All functions which could previously be performed with V.A.G 1551 can now also be carried out with the tester VAS 5051.
Indicated on display:
| Rapid data transfer HELP Select function XX |
- Press keys -0- and -2-; 02 enters the "Check DTC memory" function.
Indicated on display:
| Rapid data transfer Q 02 - Check DTC memory |
- Confirm entry with Q key.
The number of stored DTCs or "No DTC recognized" appears in the display.
| X DTCs recognized! |
- Press → key.
The stored DTCs are displayed and printed out one after the other.
- With DTC information print-out, eliminate malfunction according to DTC table, Diagnostic Trouble Code (DTC) table .
As with "No DTC recognized", the program returns to the start position after pressing the → key:
Indicated on display:
| Rapid data transfer HELP Select function XX |
- End output (Function 06). Refer to Diagnostic Trouble Code (DTC) memory, erasing and ending output .
- Switch off ignition and unplug diagnostic connector.
Work sequence if a DTC has been recognized:
1. Repair malfunction according to DTC table. Refer to Diagnostic Trouble Code (DTC) table
2. Check DTC memory (Function 02)
3. Erase DTC memory (Function 05)
4. End output (Function 06)
5. Perform a test drive
6. Check DTC memory again