Diagnostic Trouble Code (DTC) memory, erasing and ending output
WARNING: This page is about a different variant/trim than selected.
NOTE:
All functions which could previously be performed with V.A.G 1551 can now also be carried out with the tester VAS 5051.
Prerequisites:
- DTC memory checked. Refer to Diagnostic Trouble Code (DTC) memory, checking .
1. Erasing DTC memory
- Press → key.
Indicated on display:
| Rapid data transfer HELP Select function XX |
- Press keys -0- and -5-; 05 enters the "Erase DTC memory" function.
Indicated on display:
| Rapid data transfer Q 05 Erase DTC memory |
- Confirm entry with Q key
Indicated on display:
| Rapid data transfer → DTC memory is erased! |
- Press → key.
Indicated on display:
| Rapid data transfer HELP Select function XX |
Indicated on display:
| Warning! DTC memory was not interrogated. |
NOTE:
Adhere exactly to test sequence: First check DTC, then erase
2. Ending output
- Press keys -0- and -6-, this ends the output.
Indicated on display
| Rapid data transfer Q 06 - End output |
- Confirm input with Q key.
Indicated on display:
| Rapid data transfer HELP Select function XX |
- Switch off ignition.
- Disconnect Connection to V.A.G 1551 scan tool.
- Switch on ignition.
ABS warning light -K47- must go out after approx. 2 seconds.