Transmission housing, servicing: Notes
WARNING: This page is about a different variant/trim than selected.
The following list pertains to Fig 1.
- Transmission housing
- When replacing: adjust differential, see DIFFERENTIAL, ADJUSTING
- Dowel sleeves
- Qty: 2
- Oil seal
- Always replace
- Back-up light switch -F4-
- 20 N.m (15 ft lb)
- Cover
- Vent sleeve
- Remove using pliers
- Drive in against shoulder
- Selector shaft
- Removing, see ASSEMBLING
- Installing, see TRANSMISSION HOUSING, SERVICING
- Stop cover
- With ball sleeve, up to 4/93 production
- Ball sleeve discontinued in production after 4/93
- New cover without ball sleeve can be installed in all transmissions
- Spring
- Retaining plate
- Hold retaining plate in position when removing circlip -11-
- Carefully release pressure on spring -9-
- Circlip
- Always replace
- Output shaft needle bearing
- Removing, see Removing output shaft needle bearing
- Installing, see Installing output shaft needle bearing
- Ball sleeve for selector shaft
- Removing, see Extracting selector shaft ball sleeve
- Installing, see Installing selector shaft ball sleeve
- Oil seal for selector shaft
- Can be removed and installed with transmission in place
- Fill area between sealing lips with multi-purpose grease
- Removing, see Removing selector shaft seal -A-
- Installing, see Installing selector shaft seal
- Protective cover for selector shaft
- Outer race for differential tapered roller bearing
- Removing and installing, see DIFFERENTIAL, DISASSEMBLING AND ASSEMBLING
- When replacing: adjust differential, see DIFFERENTIAL, ADJUSTING
- Shim S1
- Adjustment summary, see ADJUSTMENT SUMMARY
- Sealing ring for drive flange
- Replacing, see DRIVE FLANGE OIL SEALS, REMOVING AND INSTALLING