Adjustment summary
WARNING: This page is about a different variant/trim than selected.
When servicing the transmission, adjustment of the output shaft (pinion), final drive gear or gear set is necessary only if components that have a direct effect on the adjustment of the final drive unit are replaced. Refer to the COMPONENT ADJUSTED REFERENCE table to avoid unnecessary adjustment!
COMPONENT ADJUSTED REFERENCE
| Component to be adjusted | ||
|---|---|---|
| Output shaft See OUTPUT SHAFT, ADJUSTING |
Differential (shims S1 and S2) See DIFFERENTIAL, ADJUSTING |
|
| Part being replaced: Transmission housing | X | |
| Clutch housing | X | X |
| Tapered roller bearing for differential | X | |
| Differential gear set | X | |
| Differential housing | X | |
| Output shaft tapered roller bearing | X | |