LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2025 >> RAV4 Plug-In Hybrid XSE >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 15 (Lighting System (Ext) - Service Information (2 Of 2)) >> Hazard Warning Switch >> Installation [11/2018 - 10/2022] >> Procedure

Installation [11/2018 - 10/2022]: Procedure

WARNING: This page is about a different variant/trim than selected.
  1. INSTALL HAZARD WARNING SIGNAL SWITCH ASSEMBLY 
    1. Connect the connector.
      GTY907624Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Attach the claw to install the hazard warning signal switch assembly.
      GTY907626Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  2. INSTALL NAVIGATION ECU WITH BRACKET (w/ Navigation System) 

    Refer to PROCEDURE - Step 7 [11/2018 - 10/2019] , or refer to PROCEDURE - Step 7 [10/2019 - 10/2022]

  3. INSTALL LOWER CENTER INSTRUMENT PANEL FINISH PANEL 

    Refer to PROCEDURE - Step 28 [11/2018 - 08/2020] , or refer to PROCEDURE - Step 27 [08/2020 - 10/2022]

  4. INSTALL AIR CONDITIONING CONTROL ASSEMBLY 

    Refer to PROCEDURE - Step 1

  5. INSTALL CONSOLE BOX ASSEMBLY 

    Refer to INSTALLATION [11/2018 - 12/2021] , or refer to INSTALLATION [12/2021 - ]

  6. INSTALL RADIO AND DISPLAY RECEIVER ASSEMBLY 

    Refer to PROCEDURE - Step 3

  7. INSTALL CENTER UPPER INSTRUMENT CLUSTER FINISH PANEL 

    Refer to PROCEDURE - Step 34 [11/2018 - 08/2020] , or refer to PROCEDURE - Step 33 [08/2020 - 10/2022]

  8. CONNECT CABLE TO NEGATIVE AUXILIARY BATTERY TERMINAL 
    NOTE:

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

    Refer to INITIALIZATION [11/2018 - 02/2019] , or refer to INITIALIZATION [02/2019 - 10/2019] , or refer to INITIALIZATION [10/2019 - 06/2020] , or refer to INITIALIZATION [06/2020 - 08/2020] , or refer to INITIALIZATION [08/2020 - 12/2021] , or refer to INITIALIZATION [12/2021 - 10/2022]

  9. INSTALL BATTERY HOLE COVER (for HV Model) 

    Refer to PROCEDURE - Step 3 [11/2018 - 08/2020] , or refer to PROCEDURE - Step 3 [08/2020 - ]

  10. INSTALL REAR NO. 2 FLOOR BOARD (for HV Model) 

    Refer to PROCEDURE - Step 4 [11/2018 - 08/2020] , or refer to PROCEDURE - Step 4 [08/2020 - ]

  11. INSTALL DECK BOARD ASSEMBLY (for HV Model) 

    Refer to PROCEDURE - Step 5 [11/2018 - 08/2020] , or refer to PROCEDURE - Step 5 [08/2020 - ]

  12. PERFORM SYSTEM INITIALIZATION AND CALIBRATION 

    Refer to CAUTION / NOTICE / HINT , or refer to REMOVAL [02/2019 - 10/2019] , or refer to REMOVAL [10/2019 - 08/2020] , or refer to REMOVAL [08/2020 - 12/2021] , or refer to REMOVAL [12/2021 - 10/2022] 

scientia non olet · About LEMON Manuals