LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2021 >> Venza XLE >> Repair and Diagnosis >> Body & Frame >> Door Locks >> Theft Deterrent System - Service Information >> ELECTRICAL KEY OSCILLATOR (for Rear Floor) >> Removal [10/2022 - ] >> Procedure

Removal [10/2022 - ]: Procedure

  1. REMOVE REAR NO. 2 FLOOR BOARD 

    Refer to PROCEDURE - Step 2

  2. REMOVE BATTERY HOLE COVER 

    Refer to PROCEDURE - Step 6

  3. DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL 

    Refer to PROCEDURE - Step 4

  4. REMOVE REAR SEAT CUSHION ASSEMBLY 

    Refer to PROCEDURE - Step 5

  5. REMOVE REAR SEAT CUSHION LOCK HOOK 

    Refer to PROCEDURE - Step 6

  6. REMOVE NO. 2 INDOOR ELECTRICAL KEY ANTENNA ASSEMBLY 
    1. Disconnect the connector.
      GTY1013591Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Disengage the clamp to remove the No. 2 indoor electrical key antenna assembly.
      NOTE:

      Be careful when removing the No. 2 indoor electrical key antenna assembly. If the No. 2 indoor electrical key antenna assembly is dropped, replace it with a new one.

scientia non olet · About LEMON Manuals