- REMOVE FRONT WHEEL LH
Refer to REMOVAL [09/2016 - 07/2020]
, or refer to REMOVAL [07/2020 - ]
- REMOVE FRONT FENDER LINER LH
Refer to PROCEDURE - Step 2
- REMOVE RADIATOR SUPPORT OPENING COVER
Refer to PROCEDURE - Step 3 [09/2016 - 05/2019]
, or refer to PROCEDURE - Step 3 [05/2019 - ]
- REMOVE HOOD LOCK ASSEMBLY
- Disconnect the connector.
 Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
|
- Using a screwdriver with its tip wrapped with protective tape, remove the hood lock nut cap.
 Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
|
- Remove the 2 bolts and hood lock bolt.
 Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
|
- Disconnect the hood lock control cable assembly to remove the hood lock assembly.
 Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
|
- REMOVE NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY
Refer to PROCEDURE - Step 9 [09/2016 - 05/2019]
, or refer to PROCEDURE - Step 9 [05/2019 - 07/2020]
, or refer to PROCEDURE - Step 9 [07/2020 - ]
- DISCONNECT HOOD LOCK CONTROL LEVER SUB-ASSEMBLY
Refer to PROCEDURE - Step 10 [09/2016 - 05/2019]
, or refer to PROCEDURE - Step 10 [05/2019 - 07/2020]
, or refer to PROCEDURE - Step 10 [07/2020 - ]
- REMOVE HOOD LOCK CONTROL LEVER SUB-ASSEMBLY
- Disconnect the hood lock control cable assembly to remove the hood lock control lever sub-assembly.
 Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
|
- REMOVE HOOD LOCK CONTROL CABLE ASSEMBLY
- Using a screwdriver, disengage the 4 clamps and grommet as shown in the illustration.
 Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
|
| *1 |
Hood Lock Control Cable Assembly |
- |
- |
| *a |
Clamp |
*b |
Grommet |
HINT:
Tape the screwdriver tip before use.
- Pull the hood lock control cable assembly from the engine compartment to remove it.