LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2021 >> Camry LE, FWD >> Repair and Diagnosis >> Brakes >> Parking Brake System >> Parking Brake System - Service Information (Except Hybrid) >> PARKING BRAKE CABLE (for Front Side) >> Removal [06/2017 - 09/2019] >> Procedure

Removal [06/2017 - 09/2019]: Procedure

  1. REMOVE PARKING BRAKE PEDAL ASSEMBLY 

    Refer to REMOVAL [06/2017 - 10/2020] 

  2. REMOVE FRONT SEAT ASSEMBLY LH 

    For TMC Made Power Seat: Refer to REMOVAL [03/2017 - 09/2019]

    For TMMK Made Power Seat: Refer to REMOVAL [06/2017 - 10/2020]

    For TMMK Made Manual Seat: Refer to REMOVAL [06/2017 - 10/2020]

  3. REMOVE FRONT SEAT ASSEMBLY RH 

    For TMC Made Manual Seat: Refer to REMOVAL [03/2017 - 09/2019]

    For TMMK Made Power Seat: Refer to REMOVAL [06/2017 - 10/2020]

    For TMMK Made Manual Seat: Refer to REMOVAL [06/2017 - 10/2020]

  4. REMOVE CONSOLE BOX ASSEMBLY 

    Refer to REMOVAL [06/2017 - 09/2019]

  5. DISCONNECT REAR CENTER SEAT OUTER BELT ASSEMBLY (for Fold Down Seat Type) 

    For TMC Made: Refer to PROCEDURE - Step 3

  6. REMOVE REAR SEAT CUSHION ASSEMBLY 

    For TMC Made Fold Down Seat Type: Refer to PROCEDURE - Step 4

    For TMMK Made Fold Down Seat Type: Refer to PROCEDURE - Step 7

    For TMMK Made Fixed Seat Type: Refer to PROCEDURE - Step 3

  7. REMOVE REAR SEAT CUSHION LOCK HOOK 

    For Fold Down Seat Type: Refer to PROCEDURE - Step 8

    For Fixed Seat Type: Refer to PROCEDURE - Step 4

  8. DISCONNECT FRONT DOOR OPENING TRIM WEATHERSTRIP LH 

    Refer to PROCEDURE - Step 4

  9. REMOVE REAR DOOR SCUFF PLATE LH 

    Refer to PROCEDURE - Step 11 [06/2017 - 08/2018] , or refer to PROCEDURE - Step 11 [08/2018 - 09/2019]

  10. DISCONNECT REAR DOOR OPENING TRIM WEATHERSTRIP LH 

    Refer to PROCEDURE - Step 6

  11. REMOVE LOWER CENTER PILLAR GARNISH LH 

    Refer to PROCEDURE - Step 15 [06/2017 - 08/2018] , or refer to PROCEDURE - Step 15 [08/2018 - 09/2019]

  12. REMOVE FRONT DOOR SCUFF PLATE RH 

    HINT: 

    Use the same procedure as for the LH side.

  13. REMOVE COWL SIDE TRIM SUB-ASSEMBLY RH 

    HINT: 

    Use the same procedure as for the LH side.

  14. DISCONNECT FRONT DOOR OPENING TRIM WEATHERSTRIP RH 

    HINT: 

    Use the same procedure as for the LH side.

  15. REMOVE REAR DOOR SCUFF PLATE RH 

    HINT: 

    Use the same procedure as for the LH side.

  16. DISCONNECT REAR DOOR OPENING TRIM WEATHERSTRIP RH 

    HINT: 

    Use the same procedure as for the LH side.

  17. REMOVE LOWER CENTER PILLAR GARNISH RH 

    HINT: 

    Use the same procedure as for the LH side.

  18. REMOVE NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY 

    Refer to PROCEDURE - Step 32

  19. REMOVE ACCELERATOR PEDAL 

    Refer to REMOVAL [06/2017 - 09/2019]

  20. REMOVE FRONT FLOOR CAUTION PLATE COVER (for TMC Made) 

    Refer to PROCEDURE - Step 26

  21. DISCONNECT FRONT FLOOR CARPET ASSEMBLY 
    1. For LH Side:
      1. Using a clip remover, remove the 2 front floor carpet clips.
        GTY748874Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
        Fastener - -
      2. Disengage the 3 guides.
      3. Disengage each fastener and turn back the front floor carpet assembly as shown in the illustration.
    2. For RH Side:
      1. Using a clip remover, remove the 2 front floor carpet clips.
        GTY742503Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      2. Disengage the 3 guides.
      3. Turn back the front floor carpet assembly as shown in the illustration.
  22. REMOVE REAR NO. 2 AIR DUCT 
    1. Disengage the 4 claws to remove the rear No. 2 air duct as shown in the illustration.
      GTY765748Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      Remove in this Direction
  23. REMOVE REAR NO. 1 AIR DUCT 

    Refer to PROCEDURE - Step 28

  24. REMOVE NO. 1 CONSOLE BOX DUCT (for Dual Type) 
    1. Remove the clip.
    2. GTY742320Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      Remove in this Direction

      Remove the No. 1 console box duct as shown in the illustration.

  25. REMOVE NO. 2 INDOOR ELECTRICAL KEY ANTENNA ASSEMBLY (w/ Smart Key System) 

    Refer to PROCEDURE - Step 2

  26. SEPARATE NO. 1 PARKING BRAKE CABLE ASSEMBLY 
    1. For Type A:
      1. Separate the No. 1 parking brake cable assembly from the No. 1 parking brake pull rod sub-assembly as shown in the illustration.
        GTY759827Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
        *a Turn
        *b Hold
    2. For Type B:
      1. Slide the rubber boot as shown in the illustration.
        GTY874128Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
        *1 No. 1 Parking Brake Cable Assembly
        *2 Parking Brake Equalizer
        *a Rubber Boot
      2. Separate the No. 1 parking brake cable assembly from the parking brake equalizer as shown in the illustration.
  27. REMOVE BRAKE PEDAL SUPPORT ASSEMBLY 

    Refer to REMOVAL [06/2017 - 10/2020]

  28. REMOVE NO. 1 PARKING BRAKE CABLE ASSEMBLY 
    1. GTY742467Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

      Disengage the 4 clamps.

    2. Remove the 2 nuts, and separate the brake pedal support base from the vehicle body.
      NOTE:

      Do not damage the air conditioner unit assembly when separating the brake pedal support base from the vehicle.

      HINT: 

      Separate the brake pedal support base just enough to gain access to the nut of the No. 1 parking brake cable assembly.

    3. Remove the nut.
      GTY769409Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    4. Remove the 3 bolts, nut and No. 1 parking brake cable assembly.
      GTY768661Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
scientia non olet · About LEMON Manuals