Removal [03/2020 - ]: Procedure

1. Apply protective tape to the area shown in the illustration.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   Protective Tape

2. Disengage the 3 clips in the order shown in the illustration.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   	Place Hand Here
   	Remove in this Direction

3. Disengage the 4 clips and 3 guides in the order shown in the illustration.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   	Place Hand Here
   	Remove in this Direction

4. Disconnect the connector to remove the No. 1 meter hood cluster.

1. Disengage the 5 clips in the order shown in the illustration.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   	Place Hand Here
   	Remove in this Direction

2. Disengage the 6 clips in the order shown in the illustration to remove the No. 2 instrument panel garnish sub-assembly.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   	Place Hand Here
   	Remove in this Direction

1. Disengage the clip, claw and 2 guides to remove the instrument panel finish plate garnish as shown in the illustration.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   Remove in this Direction

1. Disengage the 2 clips as shown in the illustration.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   	Place Hand Here
   	Remove in this Direction

2. Disengage the 5 clips as shown in the illustration.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   	Place Hand Here
   	Remove in this Direction

3. Disengage the clamp.
4. Disconnect each connector to remove the lower center instrument panel finish panel.

for UB80E:

Refer to PROCEDURE - Step 2

for UA80E:

Refer to PROCEDURE - Step 2

for UB80F:

Refer to PROCEDURE - Step 2

for UB80E:

Refer to PROCEDURE - Step 1

for UA80E:

Refer to PROCEDURE - Step 1

for UB80F:

Refer to PROCEDURE - Step 1

1. Move the shift lever to N.
2. Using a moulding remover, disengage the 2 claws and 2 clips as shown in the illustration.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   Insert Moulding Remover Here

   Remove in this Direction

3. Disengage the 5 claws and 4 clips as shown in the illustration.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   Place Hand Here

   Remove in this Direction

4. Disengage the clamp.
5. Disconnect each connector to remove the rear upper console panel sub-assembly.

for UB80E:

Refer to PROCEDURE - Step 1

for UA80E:

Refer to PROCEDURE - Step 1

for UB80F:

Refer to PROCEDURE - Step 1

1. Remove the 5 screws and front console box insert sub-assembly.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

1. Remove the 3 screws.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

2. Disengage the 2 claws to remove the instrument panel cup holder.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

1. Remove the console box carpet as shown in the illustration.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   Remove in this Direction

1. Remove the 4 bolts, 2 screws and console box assembly.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002