Installation [12/2015 - 08/2016]: Procedure

WARNING: This page is about a different car, the 2016 Toyota Sienna. However, it is still accessible from the selected car via links, so may be relevant.

INSTALL THERMOSTAT

Install a new gasket to the thermostat.

Install the thermostat with the jiggle valve facing up.

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

TEXT IN ILLUSTRATION

*1	Jiggle Valve

HINT:

The jiggle valve may be set within 10° on either side of the prescribed position.

INSTALL WATER INLET
1. Install the water inlet with the 2 nuts.
  Torque: 10 N*m (102 kgf*cm, 7 ft.*lbf)
INSTALL NO. 2 IDLER PULLEY SUB-ASSEMBLY
Refer to PROCEDURE - Step 7
CONNECT NO. 2 RADIATOR HOSE
1. Connect the No. 2 radiator hose to the water inlet.
INSTALL V-RIBBED BELT
(Refer to INSTALLATION [12/2015 - 08/2016] )
ADD ENGINE COOLANT
See step 4
WARM UP ENGINE
INSPECT FOR COOLANT LEAK
Refer to PROCEDURE - Step 1
INSTALL V-BANK COVER SUB-ASSEMBLY
Refer to PROCEDURE - Step 95
INSTALL FRONT BUMPER COVER
(Refer to INSTALLATION [12/2015 - 11/2017] )
INSTALL NO. 1 ENGINE UNDER COVER
Refer to PROCEDURE - Step 15