LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2017 >> Avalon XLE Plus >> Repair and Diagnosis >> Accessories & Equipment >> Infotainment >> Navigation System (Service Information) (Except Hybrid) >> Navigation Receiver >> Installation [10/2014 - ] >> Procedure

Installation [10/2014 - ]: Procedure

  1. INSTALL NAVIGATION ECU SUB-ASSEMBLY 
  2. INSTALL STEREO COMPONENT TUNER ASSEMBLY (w/ Satellite Radio) 
  3. INSTALL NO. 1 NAVIGATION WIRE (w/ Satellite Radio) 

    Refer to PROCEDURE - Step 2

  4. INSTALL AIR CONDITIONING CONTROL ASSEMBLY 

    Refer to PROCEDURE - Step 1

  5. INSTALL NO. 2 RADIO RECEIVER BRACKET 

    Refer to PROCEDURE - Step 5

  6. INSTALL NO. 1 RADIO RECEIVER BRACKET 

    Refer to PROCEDURE - Step 6

  7. INSTALL CENTER UPPER INSTRUMENT CLUSTER FINISH PANEL 

    Refer to PROCEDURE - Step 7

  8. INSTALL NAVIGATION RECEIVER ASSEMBLY WITH AIR CONDITIONING CONTROL ASSEMBLY 
    1. Connect each connector.
    2. Engage the 4 clips to temporarily install the navigation receiver assembly with air conditioning control assembly.
    3. Connect the connector.
    4. Install the navigation receiver assembly with air conditioning control assembly with the 4 bolts.
  9. INSTALL INSTRUMENT CLUSTER FINISH PANEL ASSEMBLY 

    Refer to PROCEDURE - Step 5

  10. INSTALL LOWER CENTER INSTRUMENT PANEL FINISH PANEL 

    Refer to PROCEDURE - Step 8 and PROCEDURE - Step 8

  11. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL 
    NOTE:

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Refer to INITIALIZATION [10/2014 - 10/2015] or INITIALIZATION [10/2015 - ] ).

  12. REPLACED OPERATION (w/ Parking Assist Monitor System) 

    (Refer to INITIALIZATION [10/2014 - 10/2015] or INITIALIZATION [10/2015 - ] )

scientia non olet · About LEMON Manuals